
GLASS EYE SHIELD
Installation Instructions
For use on all Glastar Models (except the G5/STARLET) and all Inland Models
- Cut a piece of double-strength glass to the size you feel will be appropriate for an eye shield.
We recommend an 8" x 9" (20,32 cm x 22,86cm) piece for large grinders and 7" x 7"
(17,78 cm x 17,78 cm) for the smaller models. The support will accommodate any size you choose. - Grind all the edges and round the corners of the glass to remove any sharp spots.
- Select two self-threading screw and washers according to the following table:
- Find the drawing below which shows your model. Place the eye shield support on the work surface
in the position indicated and secure it with the proper screws and washers.
BE CAREFUL Do not over-tighten! These screws require very little tension to hold the support in place.
G7 SUPERSTAR |
Gold Color, #12 |
G6 (Also G3 & G4 with |
Silver Color, #14 |
All Inland Models |
Silver Color, #14 |
G7 SUPERSTAR, |
G6 |
INLAND WIZARD & OLD |
INLAND "POP TOP" WIZ & |